Zwift 3D-printable accessories

---

Zwift Ride phone charger mount, compatible with MagSafe 25W

This is a phone mount to fit Zwift Ride and hold your phone in position at a comfortable angle.  Phones can be used in portrait or landscape orientation.  The 3D printed part replaces the Zwift Ride Stem Front Cover and uses the same hex bolt to fix in place.  

It is designed to be used with the Apple MagSafe charger (25W version with braided cable), which you will need to buy separately.  The charger puck should press-fit snugly into the 3D printed part, but if yours fits slightly loose it can be secured with a small piece of double sided sticky tape. Please check the compatibility of your phone and case with this charger.  Other manufacturers’ chargers are unlikely to fit the mount without modification.

This part is not compatible with the Zwift Ride Tablet holder, and is not an official Apple product.

• Print time: 5 hours 
• Print weight: 134g

---

Click mounts for road (31.8mm) diameter bars

This is a pair of 3D-printable mounts that fit to your 31.8mm diameter road handlebars.  You’ll need two M4x15mm screws to clamp these to your bars.

• Print time: 40min – each
• Print weight: 9g – each

---

Click mounts for hybrid/MTB (22.2mm diameter) handle bars

This is a pair of 3D-printable mounts that fit to your 22.2mm diameter hybrid or MTB handlebars.  You’ll need two M4x15mm screws to clamp these to your bars.

• Print time: 30min – each
• Print weight: 8g – each

---

Click mount for the Garmin computer mount

This 3D-printable mount fits securely to your existing Garmin mount, allowing you to snap in your Click controllers side by side.

• Print time: 50min
• Print weight: 19g

---

Click mount for the Wahoo computer mount

This 3D-printable mount fits securely to your existing Wahoo mount, allowing you to snap in your Click controllers side by side.

• Print time: 45min – each
• Print weight: 13g – each

---

Click mounts for TT bars

This is a pair of 3D-printable mounts that will fit in standard TT extensions for control in the skis.

• Print time: 45min – each
• Print weight: 13g – each

---

We use a Bambu printer, and recommend these settings

• Layer height: 0.2
• Nozzle size: 0.4
• Material: PLA / PETG
• Support – Tree

These downloadable STL files can be used with most 3D printers to create a physical part. If you use a different printer type or manufacturer, then please consider using your recommended settings.

For those Zwifters that don’t own 3D printers, there are online services available that can print these files.

---

These design files are licensed under CC BY-NC-SA 4.0.  All designs and files are provided “as is”, without any warranties or representations made.  The full license is included with each download file.

The mounts are not designed to support heavy loads; users should apply moderate pressure to the mounts and be mindful not to rest on them (e.g. while sprinting).

---

We’d like to hear from you. Please direct any feedback, comments or photos of your mounts in action to our Forum page, here.